After a lot of research, I managed to solve this error that happens to the Parktronic (PARKMAN213) module after flashing. Basically the error means that the coding is incomplete, even if you have coded the module with DTS Monaco. The reason the error happens, is because Monaco on the VarCode tab only codes domains that are different than what is already on the unit. It does not recode the same value, but Parkman wants to be coded even if the value is the default one.
So what you can do is this:
Go to Diagnostic Services and run this:
[22] Coding strings status Read
It will give you the critical domains and their status, either CODED or NOT CODED. For the error to go away all domains need to appear as CODED. Find the domains that are "NOT CODED" and do variant coding from the Diagnostic Services.
For me, the relevant services were:
[2E] Configuration of trailer coupling fading Write
[2E] Activate SAR Data Storage Write
After manually coding the two domains the status should change to CODED and Parkman should be functional again and the error no longer current.
So what you can do is this:
Go to Diagnostic Services and run this:
[22] Coding strings status Read
It will give you the critical domains and their status, either CODED or NOT CODED. For the error to go away all domains need to appear as CODED. Find the domains that are "NOT CODED" and do variant coding from the Diagnostic Services.
For me, the relevant services were:
[2E] Configuration of trailer coupling fading Write
[2E] Activate SAR Data Storage Write
After manually coding the two domains the status should change to CODED and Parkman should be functional again and the error no longer current.
